Couesnon & Cie

Serial  #none   Batch marks don’t match. The clarinet is unmarked except for the hard rubber bell, but the keyed joints and bell clearly seem to belong together. The barrel is an H. Selmer. I would guess that the Couesnon parts were made in the late 1920s. The top of the LH joint is stamped LP (low pitch). Usually I say that makers stopped doing that around 1920, but I din’t think that hard rubber bell started appearing that early. Because of the hard rubber bell and the lack of stamping on the keyed joints, this was definitely made as a student clarinet.
Barrel:  62.4mm
Bore LH joint top: 14.4mm
Bore LH joint at bottom:  14.2mm narrow bore

Intonation results taken when playing loud and not lipping. See how to interpret these results on the Model Comparison Page.

For this test, I pulled 0  at the barrel and 1.4mm  in the center for this horn.
High registerAndroid PitchLab
F0
E0
D3
C6
B10
B-flat10
A16
Mid
G0
F5
E0
D5
C6
B0
Throat tones
Bb-5
A5
G-5
F-1
E-2
Chalemeau
D15
C5
B-flat10
A4
G0
F4
E12


Intonation summary: This instrument is not all that bad for a narrow bore horn. And I am testing it with my Prime mouthpiece, which has an exit bore of 14.9mm. So some notes might be improved with a period mouthpiece and the original barrel. The Chalemeau D and the high register A are both sharp by a lot, but this could be fixed a bit by filling in that tone hole a bit. Whoever plays this should learn to use the throat tone Bb with the right hand third trill key.

Key work quality: Typical Couesnon key quality. They are sturdy enough for the player who is careful in assembling and disassembling.

This clarinet is most appropriate for: Beginners, or adults interested in the sweet tone of a narrow bore instrument.



Comments